Home › Showroom › i-Check introduction

i-Check introduction

THE HIGH-TECH WIRELESS TIRE PRESSURE MONITORING SYSTEM

THE MOST AFFORDABLE, ACCURATE AND RELIABLE TIRE PRESSURE MONITORING SYSTEM CURRENTLY AVAILABLE

i-Check, the Wireless Tire Pressure Monitor System (TPMS).No wire is required between the sensors and display panel. i-Check comes with 4 sensors, a central display which is powered by the cigarette lighter plug.

i-Check, the Wireless Tire Pressure Monitor System (TPMS) keeps you informed while you're on the roll. When a tire is losing pressure, i-Check provides an early warning. In short, i-Check will :

• Secure Vehicle Safety
• Improve Fuel Economy
• Enhance Vehicle Performance
• Increase Tire Life

SENSORS

i-Check uses a special wireless protocol to allow a driver to detect loss of tire pressure. At the core of the technology are specialized transmitters. Each transmitter contains an integrated circuit with an unique identification, making sure that cross talking between vehicles is impossible.

CENTRAL DISPLAY

The central display shows the actual information of all tires. By pressing a button, the actual pressure of each tire will be displayed. During the trip every 10 seconds, the status of a different tire will be shown, but as soon as a pressure drops below the preset value, the display will immediately jump to that tire and show the actual values, while sounding an alarm.

Installation of TPMS Kit

		Step 1 • Assemble the supplied air valve stem, screw & washer pack to the Sensor Unit. • Do not tightened the screw until suitable valve stem angle are match on vehicle wheel. • Check stem-sensor angle on wheel.
		Step 2 • Install the sensor on the wheel and make sure the screw is tightened properly. • Re-load the tyre pressure to specify pressure check your car owner manual for appropriate pressure setting.
		Step 3 • All 4 tyre pressure should be seen cleary on the TPMS monitor. • Minor adjustment can be done on tyre pressure to match factory setting.
		Step 4 • If you see 1 of the readings in red and very low number on display, double check the wheel again, and make sure tyre condition and sensor fitment are normal. All reading should be GREEN after installed. • If RED reading occur during your driving, this indicate pressure on wheels is too low, stop driving and visit your workshop immediately.

ADVANTAGES

• Fast and easy installation on almost any vehicle.
• Supports tire rotation.
• Real-time display of all tires condition.
• Superior design.

i-CHECK SAVES YOUR MONEY!

• Check no costly installation.
• Properly inflated tired save fuel.
• Properly inflated tires extend the life of tire treads by as much as 35%.
• Properly inflated tires last longer.
• The monitor of i-Check can easily be relocated from the primary to the other vehicle.

i-CHECK KEEPS YOU SAFE!

• Tire air pressure is constantly monitored while moving or parked.
• i-Check easily check your tires for proper inflation, which can prevent dangerous conditions that can cause to accident.
• Greater stability, handling and braking with properly inflated tires.
• i-Check greatly improves your ability to react to sudden tire air pressure loss.
• The low pressure alert is immediately displayed on the dashboard monitor, and indicates the failing tire’s pressure.
• The system of i-Check can allow drivers to instantly respond to an audible beep and a visual alert emitted by the dashboard monitor when tire pressure falls to dangerous levels.

back to top